The tab of the ZMC component lists the network interfaces available on the host, along with their type, IP addresses, and connected zones.
| Tip |
|---|
|
If no one or more physical interfaces of the host are listed here, it is most likely because they were not configured before bootstrapping took place. The bootstrapping process not only establishes the connection between ZMS and the host (Management agents on it), but it also queries host configuration, and inserts this information into the ZMS database. When selecting a host entry in ZMC, the information is read from the ZMS database, and not from the host directly. Therefore, ZMC does not detect parameters that were unavailable for ZMS during bootstrapping. To correct this situation, define the missing interface(s): click and configure them as required. |
If the interface settings are changed, in order to activate the changes, restart the modified network interface. Additionally, it may be required to temporarily stop an interface for security or maintenance reasons with the button under the network interface listing.
| Warning |
|---|
Restarting the interface might terminate all ongoing connections of the interface. |
| Note |
|---|
The interfaces are controlled individually. |
Published on May 30, 2024
© BalaSys IT Ltd.
Send your comments to support@balasys.hu
