13.1.5. Procedure – Configuring MS database save

With the Database settings (database) parameter you can set how frequently the MS database is saved to disk in both idle and active modes.

1. Select the appropriate number in the Idle threshold field to determine the interval between two database backups when the MS XML database is not in use, that is, no changes are committed.

   Give values in seconds. The default value is 10. All values are allowed.

2. Select the appropriate number in the Busy threshold field to determine the interval between two database backups when the MS XML database is used and changes are committed.

   Give values in seconds. The default value is 120. All values are allowed.

   Note
   Since the XML database is constantly updated when the MS is in use you are recommended to keep busy threshold value not too low to decrease system load. On the other hand, when choosing high threshold values it is important to bear in mind that during any system breakdown or power outage data might get lost because the database is kept only in the memory and not saved to disk.

   

   Figure 13.13. XML database settings

3. By default, MS sends warnings a week before a certificate expires. You can modify this value here.