12.4.3. Procedure – Adding a new node to a PNS cluster
Click the
button on the tab of the cluster.Set the properties of the new node in the appearing window. Enter hostname, agent bind address and bind port, and any other properties that have been added to the cluster.
Tip It is recommended to use the default port setting.
Do not forget to check the MS database manually. Also, the node cannot be connected automatically, only through a recovery connection (see Procedure 13.3.4, Configuring recovery connections).
checkbox to automatically commit the changes and connect to the new node. If this checkbox is not selected when the new node is created, the configuration must be committed into theIf you create a failover cluster, usually the second node is configured to be the slave node.
Enter the one-time password and click the
button to build up the connection.Details on the background procedures are provided in standalone text. Save the output with the
button so that it can be analyzed later if needed. The text window shall look similar to this.Note You can check the status and connections of cluster nodes by selecting the
item in the menu.After bootstrapping a cluster and adding new properties, you can freely add the necessary components and configure the nodes according to your needs. Basically, the configuration procedure is similar to a PNS host configuration. When configuring clusters using the component, proceed to Procedure 12.5.3.1, Configure Keepalived.
© 2021 BalaSys IT Security.
Send your comments to support@balasys.hu