zorp
zorp — Zorp Firewall Suite
Synopsis
zorp [options]
Description
The zorp command is the main entry point for a Zorp instance, and as
such it is generally called by zorpctl(8) with command line
parameters specified in
instances.conf(5)
.
Options
- --version or -V
Display version number and compilation information.
- --as <name> or -a <name>
Set instance name to <name>. Instance names may consist of the characters [a-zA-Z0-9_] and must begin with a letter. Log messages of this instance are prefixed with this name.
- --no-syslog or -l
Send log messages to the standard output instead of syslog. This option implies foreground mode, overriding the contradicting process options if present.
- --log-tags or -T
Prepend log category and log level to each message.
- --log-escape
Escape non-printable characters to avoid binary log files. Each character less than 0x20 and greater than 0x7F are escaped in the form <XX>.
- --log-spec <spec> or -s <spec>
Set verbosity mask on a per category basis. Each log message has an assigned multi-level category, where levels are separated by a dot. For example, HTTP requests are logged under http.request. <spec> is a comma separated list of log specifications. A single log specification consists of a wildcard matching log category, a colon, and a number specifying the verbosity level of that given category. Categories match from left to right. E.g.: --logspec 'http.*:5,core:3'. The last matching entry will be used as the verbosity of the given category. If no match is found the default verbosity specified with --verbose is used.
- --threads <num> or -t <num>
Set the maximum number of threads that can be used in parallel by this Zorp instance.
- --idle-threads <num> or -I
Set the maximum number of idle threads; this option has effect only if threadpools are enabled (see the option --threadpools).
- --threadpools or -O
Enable the use of threadpools, which means that threads associated with sessions are not automatically freed, only if the maximum number of idle threads is exceeded.
- --user <user> or -u <user>
Switch to the supplied user after starting up.
- --group <group> or -g <group>
Switch to the supplied group after starting up.
- --chroot <dir> or -R <dir>
Change root to the specified directory before reading the configuration file. The directory must be set up accordingly.
- --caps <caps> or -C <caps>
Switch to the supplied set of capabilities after starting up. This should contain the required capabilities in the permitted set. For the syntax of capability description see the man page of cap_from_text(3).
- --no-caps or -N
Do not change capabilities at all.
- --crypto-engine <engine> or -E <engine>
Set the OpenSSL crypto engine to be used for hardware accelerated crypto support.
Published on May 30, 2024
© BalaSys IT Ltd.
Send your comments to support@balasys.hu
